Hvordan sætter man en bose 901 eq til en onkyo forstærker type TX-DS989 upg2 så den spiller opitmalt?

 

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=33020 6580960#ebayphotohosting

 

http://www.homecinemachoice.com/reviews/hccreviews/Amplifier s/Onkyo/OnkyoTX-DS989_rear.jpg

Her er billeder af begge, vil meget gerne vide hvordan præcis det skal sættes sammen

smid den imellem front og amp in

Det står en maualen:

"Home theater use
(PRE AMP OUT/MAIN AMP IN)
Use these instructions:
• for stereo-only operation if your receiver does not have a TAPE MONITOR connection.
• if you are using a surround sound receiver that has a section on the back marked PRE
AMP OUT/MAIN AMP IN. The jacks may be labeled ADAPTER or SIGNAL PROCESSOR.
Note: If your receiver does not have this PRE AMP OUT/MAIN AMP IN section, the 901
speakers will not be usable in your home theater system.
1. The PRE AMP OUT/MAIN AMP IN jacks on your receiver are usually connected by small
bars called horseshoe pins. Remove these pins. See Figure 6."

Der er en bøjle mellmen "Front" bøjler fjernes og der trekke ledning (RCA) i mellem, som der står i manualen